Will be testing flashforge 3d soon

#3DPrinted

Some are questioning X axis stability of the new Original Prusa MINI, let’s end it now. It is supported by two 10mm rods and alu extrusion. I dug up a video of my first print on first prototype where I was testing the limits. Pardon the first few layers, MBL wasn’t working yet.

Sending this tweet through space via Starlink satellite 🛰

Dr Kareem Carr Yet it is a glorified statistics 😂

We're spending #WorldSpaceWeek the only way we know how - preparing to go to space again! Check out this beautiful flock of SuperDoves from @planetlabs getting ready for their ride to orbit later this month.

My feeling about 2021. It is wide open for anything to happen #Linux #cli

It is true that implementing MFA in any form is much better than not having it, just like having better locks at your place of business, but there is a widely-touted statistic that is extremely mis-leading. ow.ly/Eodq50G1Fqi

Raspberry Pi Zero 2 W . It is amazing how they are managing to cram so much power in this thing . adafruit industries your package is dope and stands out #RaspberryPi #raspberrypizero2 #IoT

Lock your VerusID with an unlock delay. Securely stake funds. Keep your revocation and recovery keys in a cold wallet. Check your ID more often than your unlock delay, and if someone else unlocks your ID, simply revoke & recover all your assets🔥

It has been 10 years since I have been using raspberry pi. It is amazing how far Raspberry Pi have come since the first release #RaspberryPi #maker #IoT #electronics #Hardware

#100DaysOfHomeLab #2 : Decided to go ahead and install my hypervisor without updating my DL360 firmware . Too bad HPE decided to put the access to the proliant service pack behind paywall.

3dprint.com/300517/austral…

📥 3D Printable stackable foldable storage crate ➡️ 3D model: cults3d.com/:1278530 💡 Designed by Makeit3d

Gamechanging Mechanical Design App

Gradually adjusting the mixing ratios here..gradient appears pretty non-linear..but expected with different filament tinting strength.

A new design! My modular tool wall :) stls are now on Cults. : cults3d.com/:1443303

So I got the hyped Zimaboard, an x86 Fully hackable SBC #zimaboard #IoT . First project will be a DIY NAS #Storage #homelab

Who is investing in healthcare #3Dprinting startups? 3DHEALS Infographic | [email protected] | by 3DHEALS