Alex Midkiff (@alex_midkiff) 's Twitter Profile
Alex Midkiff

@alex_midkiff

I press buttons and build cool things

ID: 3257249462

calendar_today27-06-2015 02:20:41

714 Tweet

569 Followers

812 Following

Alex Midkiff (@alex_midkiff) 's Twitter Profile Photo

Picked up some more pieces to build a spare midget motor for outdoor season. Should end up making about 300 horsepower for a fraction of the cost of a national motor!

Picked up some more pieces to build a spare midget motor for outdoor season. Should end up making about 300 horsepower for a fraction of the cost of a national motor!
Alex Midkiff (@alex_midkiff) 's Twitter Profile Photo

-8 ORB fitting on the jiffy-tite is 3/4-16. 1/2-14 NPT thread is loose enough at the top of the taper that despite the difference in TPI the o-ring still seals. Adapted to the garden hose with a $6 fitting from Lowe’s and bled the engine heater I built in about 2 minutes🤓

-8 ORB fitting on the jiffy-tite is 3/4-16. 1/2-14 NPT thread is loose enough at the top of the taper that despite the difference in TPI the o-ring still seals. Adapted to the garden hose with a $6 fitting from Lowe’s and bled the engine heater I built in about 2 minutes🤓
Alex Midkiff (@alex_midkiff) 's Twitter Profile Photo

5th to 3rd in my heat race and 7th to 4th in the A main last night at Highland! Slight fueling issues that need worked out after installing a fresh motor but a good start to the outdoor season regardless

5th to 3rd in my heat race and 7th to 4th in the A main last night at Highland!

Slight fueling issues that need worked out after installing a fresh motor but a good start to the outdoor season regardless
Alex Midkiff (@alex_midkiff) 's Twitter Profile Photo

Battled some problems last night and early tonight. Got the car running good and made the necessary changes to get the job done! Thanks to everyone that makes this operation possible!