One may never see the same appliance twice: for it is not the same appliance and they are not the same technician #ReferDream ❄️

For the learners. Mark your paxolin cut out then put tape over the lines then reapply the lines on the tape. This way you get a nice clean edge cut and it helps to see the line. I still use a hand saw, takes a bit longer but always can tell paxolin cut with a jig.

Deano. Can you see if holders been ordered? Engineer said he did order new one but hasnt landed yet? New remotes a lot nicer tho 😍👌 Blame Ongas for reminding me 😂😂😂

Adam Chapman @RobsDoneARunner get your hands dirty mate 😂

For the learners. Whenever your doing a mains swap. Especially commercial/industrial always allow a prep day before the switch off. It makes the job so much easier. Even if you have to deconstruct, then reconstruct on the wall. It's not always possible but if you can do.

When your a plumber for the day but the new rad didn't come with the pinch bolts. No bother eaton mem distribution board plate screws to the rescue 😂. What you reckon DpawsonGas

New worktops and a spring clean in the bbq area.

Smash burgers last night and sausage & egg muffins with hash browns for breakfast this morning cooked on the Grillstream plancha

98% reduction in heat loss 😅 groks gotta be wrong?

Someones frustrated 😂

In 2025, my new washing machine / drying machine takes 3-5 seconds to “boot up” just so I can *select* the program In 1990 I remember our washing machine took 0 seconds to “boot up” because you just had a physical switch to select the program Sometimes progress feels backwards

Yet is lazy at calculating heat loss / manual J calculations 🙄 “ i omitted” xAI

Work experience for the boy.

Remember, if you get caught even touching your phone whilst in your car, you’ll be fined. But this is OK?

New van key 🙃

Cant beat a bit of tape 🤭

Bit of a plumber tonight 🙈

Is it a hosepipe if its got a tap on the end of it? Asking for a friend 🤭😂