How it started (First RepRanger prototype on the left) How it’s going (current RepRanger Refresh on the right)

RepRanger Refresh available on Patreon, test printed in Polymaker PolyTerra Dark Army Green and Paramount 3D Stealth Gray

Todays FAFO Winner.

Come hang out.discord.gg/nFxggg2w

This mornings hangout on discord. discord.gg/cBtjmzUT

Live til 11 discord.gg/behDYDNZ. Setting up a Raspberry pi for the MK3. May do Klipper on this b.

Streaming the morning on Discord. discord.gg/cDsug9aX

I can not believe I waited this long to pick this up. Bambu Lab X1C with AMS. Unpacked and the first print is a 4 color model for a buddy of mine at the VFW. I skipped the Benchy. Fast and first layer was oh so good. I thought it had the cool plate so I have 2 textures ones

youtube.com/live/B6tyNMHwd…

Time for Morning Coffee. Youtube.com/Kuntry3D

youtube.com/live/mCqOEhLaV…

Well it's time to rebuild the printed Hypercube EVO. Reprinting of all parts that were PLA into ABS has commenced. New bearings and other stuff ordered. I tried to get it going today, and it homed fine until I updated the firmware, now it just kinda quivers.

New parts for the 3d printed Hypercube evo. The humidity has finally taken it's toll on the PLA I used. Well new PETG is good.

My first successful print on the ELEGOO Saturn S4 Ultra. I had to replace the FEP after my first print attempt, but that is a story for another day.

Hey SliceWorx, I got the build plate and my ABS stuck super well. I got the parts off, but the brim and the priming tower and the priming lines from the X1Carbon seem to be there forever now. Any Suggestions? I have exactly one print on the plate.