Standard Friday! 🤪

Loving my wee Nimbot Bluetooth label printer 👌🏻 So much better than the old Brother beast .

Anyone else use these F4P clamps? I thought the point of making these connections was to get them tight….. the bolts on these are made of butter 🤬

Funny the things you notice in a pub toilet….. that is actually a piece of trunking 😂

Holy moly….,, working away here wondering why it is so warm….. client has the heating on!! 🤦🏼‍♂️😂

Lovely what you find under the suspiciously poorly plastered wall 🤦🏼‍♂️

I think the expression sounds a little like…clucking bell. I didn’t really think any of my jobs would qualify as 6 stories / over 18m in height but it looks like this one might as it has a basement 🤦🏼‍♂️ And it would be the one with the Hager 3 phase setup in it 🙄 The joys….

Going to give nylock nuts a try for a while…. Feels like a good way to go.

Anyone got any recommendations for very small joint boxes? This 16A Deta one was good but it is discontinued. Something even smaller would be better tbh. The little Whiska shark ones are decent and really small but I don’t always want gel filled 🤔

Plasterers at their best 👏🏻 👏🏻

Out for a bit of lunch with the Mrs…..Back to work on Monday after my wee op recovery 🥳

Shite bag ……🤦🏼‍♂️😂😂

A few fancy Flos pendants done yesterday….. quite a nice design.

Under floor relics

Working alone and nobody to keep tension on the cable while you feed it through the conduit? Problem solved 👌🏻🤣😂

Chuffed with that wee hack…. Allowed me to use the old conduit & comply given the UV box was gone and the switch was being relocated 👌🏻

Opinions please people! Lightly corroded steel/ iron duct. This is the only route to get cranes from one side of this house to the other. Would you earth back to the board or not? Cables slide through easy, no rough edges….my feeling is it’s probably isn’t necessary 🤔