Ready to go to ChaosCrewDisch9 (CCD9) tomorrow!

The Sovol S08 is a tight fit for the passenger seat of my old E92 😅

I can definitely get used to seeing “247” brandings 😬

Thanks a lot BIGTREETECH for sending over that special Kraken V1.0 💪

In Lower Bavaria it’s common to see salt coming out of tree stumps 🤪

I don't know... Some people find that number attractive... Enjoy :-D

Allow me to call the Sovol S08 the 'VolksVoron'.

The always-on electronics fan is super annoying.
For the rest: I am quite pleased and that's not easy!

Get it here - aff*:
bit.ly/THE_S08

Hope all my friends in Taiwan keep safe!

I mean, yeah, I posted about that lately. Knowing motor temperatures is a hot topic when you try to go at the limits. I am pleased to see Alan to also try and find solutions for monitoring temps.

Designed a Thermistor clamp for the 🇨🇳🇺🇸🇪🇺LDO MOTORS 2804s on the Hot Rod Trident (it needs a new name). This holds a standard NTC100k in stainless sleeve against the side of the motor body so I can monitor temps in Klipper. Inspired by Albert is 247printing monitoring his on the 247 V0.

Wanna feel good? Just watch my video and enjoy my Bavarian accent 🥰
youtu.be/mklQ-sNAud8?si…

Beautiful video - must watch 👍

247zeroB2 loves the spotlight 🙌

Btw.: 70% - 80% of the clips appearing in my content are still recorded on iPhones - a breeze to use!
Rest is 30mm makro lens shots on GX80.

Also still on super cheap soft boxes, but I have 8 of them - two in every room where I record clips.

Cooling the 5160s pros managing up to 2.8A and 58V.

I had to lift the printer 12mm from the ground (accent spacers on the feet) after switching to BIGTREETECH Octopus Pro, because of the faster MCU.

You’ll probably also notice why I haven’t released any designs yet…

This is the next generation of 3D printing. What do you think Albert is 247printing ?

Voron M4 is just awesome to watch 💪
Casual speeds (Voron 0.1 default Orca Slicer Profile) at 0.24 advance on pressure advance.

Imagine what’s going on here while printing a 2.5min benchy - need to film this (I’ve also only seen the the front view do far)

Does anyone know ABS filament that comes close to the accent 'Peach Puff' on the Lotus 97T John Player Special from 1985?

Google says this should be 'RAL1024' or 'CMYK 0, 16, 50, 29'.